17
Mounting the terminal Chapter 5
Installing the terminal
2 Mounting the terminal
A suitable mounting kit must be available. Mounting kits contains all parts needed in-
cluding screws and assembly instructions. The following mounting kits are available:
• 19-inch rack mounting kits, 1/2, 3/4 and 1/1 terminal width variants. See section 2.1.
• Side-by-side mounting kit. See section 2.2.
• Flush mounting kit. See section 2.3.
• Semi-flush mounting kit. See section 2.3.
• Wall mounting kit. See section 2.4.
Most of the REx 5xx terminals can be rack, flush, semi-flush or wall mounted with the
use of different mounting kits. An additional box of type RHGS can be mounted to one
side of a 1/2 or 3/4 terminal. The 1/1 of 19-inches wide terminal can not be semi-flush
mounted due to that the mounting angles will cover the ventilating openings at the top
and bottom parts.
To Next Page
Loading...
