19
Mounting the terminal Chapter 5
Installing the terminal
Procedure
1. Carefully fasten the mounting angles to the sides of the termi-
nal.
Use the TORX T20 screws available in the mounting kit.
2. Place the terminal assembly in the rack.
3. Fasten the mounting angles with appropriate screws.
2.2 Mounting in a 19-inch rack with an additional box type RHGS
Make sure a side-by-side mounting kit and a suitable 19-inch rack mounting kit are
available before proceeding.
Assemble the two terminals by using a side-by-side mounting kit. Then mount the
brackets and install the assembled terminals in the rack as described in section 2.1.
To Next Page
Loading...
