ABB REL 511-C1 2.5 Series - Page 34

27
Configuration &KDSWHU
8QGHUVWDQGWKH+0,WUHH
Slave number and baud rate (communication speed) must be set for both the ports.
These settings must correspond with the settings in the used PC-program. For the rear
port it is possible to set permission of changes between active setting groups, ActGr-
pRestrict, and the setting restrictions, SettingRestrict, as well.
 ,(&FRPPXQLFDWLRQ
Use this menu to set slave number and baud rate when to communicate on the IEC 870–
5–103 communications bus, also known as 6FKQLWWVWHOOH or VDEW 6. The IEC bus
uses the same rear optic port as the SPA bus, but the settings must be done separately.
 /21FRPPXQLFDWLRQ
Use this menu to view node information as address and location, (set from the LON
Network Tool), as well as the Neuron identity. Functions for address setting during in-
stallation (ServicePinMSG), LON configuration reset (LONDefault) and session timers
are also available.
 5HPRWHWHUPLQDOFRPPXQLFDWLRQ
Use this menu to configure the 56/64 kbit data communication to remote terminal. This
communication requires a certain data communication module. The parameters to set
are:
• the local terminal identity
• the remote terminal identity
• the bit rate
• the fiber optics transmitter output power (not applicable for galvanic interface)
• the terminal master/slave operation.
 7LPH
The internal terminal time can be synchronised with an external unit connected to the
SPA/IEC 60870-5-103 port or the LON port. It is also possible to use a minute pulse
synchronisation signal connected to a digital input.
 'LVWXUE5HSRUW
This menu includes all setting parameters for the disturbance report. The following fea-
ture is available:
1RWH
6HVVLRQWLPHUVDUHIRUDGYDQFHGXVDJHDQGVKRXOGRQO\EHFKDQJHGXSRQUHFRPPHQGD
WLRQIURP$%%