ABB REL670 - Directional Over-Power Protection GOPPDOP (32); Directional Under-Power Protection GUPPDUP (37); Instantaneous Phase Overcurrent Protection PHPIOC (50); Instantaneous Residual Overcurrent Protection EFPIOC (50 N)

Includes current and timer settings.
9.3.4.4
Directional over-power protection GOPPDOP (32)
Main menu/Settings/Setting Group N/Current protection/
DirOverPowerProtection(PDOP,32)/GOP
Includes power, angle and calibration factor settings.
9.3.4.5 Directional under-power protection GUPPDUP (37)
Main menu/Settings/Setting Group N/Current protection/
DirUnderPowerProtection(PDUP,37)/GUP
Includes power, angle and calibration factor settings.
9.3.4.6 Instantaneous phase overcurrent protection PHPIOC (50)
Main menu/Settings/Setting Group N/Current protection/
InstPhaseOvercurrent(PIOC,50)/IOC
Displays some instances of PHPIOC (50) with some settable parameters per instance.
Operation mode, operate current multiplier, operation on or off, operate phase current
level as a percentage of IBase, and IBase itself are the settable parameters available here.
9.3.4.7 Instantaneous residual overcurrent protection EFPIOC (50N)
Main menu/Settings/Setting Group N/Current protection/
InstResidualOverCurrent(PIOC,50N)/IEF
Displays some instances of EFPIOC (50N) with settable parameters per instance. The
settable parameters are operation (On or Off), base setting for current magnitude, the
threshold current as a percentage of IBase, and the multiplier for the current threshold
level.
9.3.4.8 Four step phase overcurrent protection OC4PTOC (51_67)
Main menu/Settings/Setting Group N/Current protection/
PhaseOverCurrent4Step(PTOC,51_67)/TOC
Displays some instances of OC4PTOC (51_67) each with several settings. The settings
range from base current and voltage settings to parameters for customer programmable
curves.
1MRK506276-UUS B Section 9
Read and change settings
57
Operator's manual