ABB Relion 605 Series - Page 68

Section 5 1MDU07212-YN Rev. D
Use of LHMI
62 REF601 / REJ601 / REM601
Application Manual
5.2.8.1 Menu – Hardware
Following functionalities can be tested through this menu.
 LCD Test
 Keyboard Test
 LED Test
Test
Hardware :YYY
Test Test
Hardware :YYY
Test Continue
YES:UP NO:ESC
NO; YESNO; YES
++
Select ‘Yes’ with:Select ‘Yes’ with: Confirm with:Confirm with:
LCD Test
Select ‘Yes’ with:Select ‘Yes’ with: Confirm with:Confirm with:
NO or timeout to confirm
will lead to exit test
NO or timeout to confirm
will lead to exit test
Test Continue
YES:UP NO:ESC
Keyboard
Test
Select ‘Yes’ with:Select ‘Yes’ with: Confirm with:Confirm with:
NO or timeout to confirm
will lead to exit test
NO or timeout to confirm
will lead to exit test
LED Test
Test Repeat?
YES:UP NO:DOWN
Select ‘Yes’ with:Select ‘Yes’ with: Confirm with:Confirm with:
NO or timeout to confirm
will lead to exit test
NO or timeout to confirm
will lead to exit test
Start Hardware testStart Hardware test
During each test wherever confirmation from user is asked to continue test
sequence, if no selection from user, automatically after 5 sec timeout test sequence
will move to next screen.
Each test procedure provides test result messages and interactive user selections on
LCD.
Test Continue
YES:UP NO:DOWN
LCD Test
LCD TEST
LCD TEST
LCD TEST
LCD TEST
Test Continue
YES:UP NO:DOWN
Figure 22: Hardware test menu of relay REF601/REJ601/REM601 with its submenu