IEC13000060 V1 EN-US
Figure 19: Select the TCP/IPv4 protocol and open Properties
5. Select Use the following IP address and define
IP address
and
Subnet mask
if the front port is
used and if the
IP address
is not set to be obtained automatically by the IED,see Figure 20.
The IP address must be different from the IP address chosen for the IED.
IEC13000062 V1 EN-US
Figure 20: Select: Use the following IP address
6. Close all open windows and start PCM600.
1MRK 500 129-UUS B Section 8
Editing the network settings
670/650 series 39
Quick start guide
To Next Page
Loading...
