EasyManua.ls Logo

ABB REM 543 - Page 99

ABB REM 543
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1MRS750915-MUM
REM 54_
99
Machine Terminal
Technical Reference Manual, General
New language versions:
English - Swedish
English - Finnish
An informative parameter, Config. capacity, added (Main menu/
Configuration/General/Config. capacity). For further
information refer to the Configuration Guideline (1MRS750745-MUM).
Menu descriptions of virtual I/Os changed to match the names in tools
48-hour capacitor back-up for the internal clock of the machine terminal
Selection of latching feature for the Start LED can be stored in the non-volatile
memory
Function blocks
Function block revision added (uploading of the function block list to CAP 505)
Measurement function blocks: outputs indicating the status of warning and alarm
limits added
Under- and overvoltage protection function blocks UV3_ and OV3_:
phase-selective start outputs added
control setting parameter Oper. hysteresis added for adjusting the level
of a comparator (for more information, refer to the CD-ROM Technical
Descriptions of Functions)
EVENT230 function block: input interface changed
Changes to input names in the following function blocks: UV3Low, UV3High,
OV3Low, OV3High, MEVO3A, CMVO3
MEPE7, the function block for power and energy measurement:
Events for energy (E), apparent power (S), and cos
ϕ added
Time-based delta event sending added
Start time range of the MotStart function block changed
from 0.3...80.0 s to 0.3... 250 s
For further information about the above changes, refer to the function block
descriptions on the CD-ROM Technical Descriptions of Functions.
New protection functions
Function Description
Diff3 High-impedance or flux-balance based differential protection for
generators and motors
FuseFail Fuse failure supervision
PREV3 Phase reversal protection
PSV3St1 Phase-sequence voltage protection, stage 1
PSV3St2 Phase-sequence voltage protection, stage 2
UI6Low Three-phase underimpedance protection, low-set stage
UI6High Three-phase underimpedance protection, high-set stage
OE1Low Overexcitation protection, low-set stage
OE1High Overexcitation protection, high-set stage

Table of Contents

Other manuals for ABB REM 543

Related product manuals