ABB REM615 ANSI 5.0 FP1 - Page 35

35
—

Characteristc 
Operation accuracy
Depending on the frequency of the measured current: f
n


n
Reset time

Reset ratio

Retardation time

Operate time accuracy in definite time mode

—

Parameter Function  Step
Operation
JAMPTOC

 —
Start value
JAMPTOC

n

Operate delay time
JAMPTOC  
—

Characteristic 
Operation accuracy
Depending on the frequency of the measured current: f
n


n
Start time

Minimum Typical Maximum
I
Fault

detection A   
Operate time accuracy 
Reset ratio 

n
, f
n
= 50 Hz, overcurrent in one phase, results based on statistical distribution of 1000 measurements
2 Includes the delay of the signal output contact
—

Parameter Function  Step
Motor start-up A
STTPMSU 
n

Motor start-up time
STTPMSU
 
Lock rotor time
STTPMSU  
Operation
STTPMSU

 —
Operation mode
STTPMSU



 —
Restart inhibit time
STTPMSU  