ABB | SACE Emax 2
Ekip Dip
2 - Operator interface
32 | © 2023 ABB | 1SDH001000R0002 - ECN000297030
2 - Operator interface
Introduction
The operator interface of the Ekip Dip protection release allows you to:
• Set the parameters relating to the available protections.
• View the status of the trip unit and alarms.
• Connect to the frontal connector to communicate and perform the opening test.
Components of the interface
The Ekip Dip operator interface appears as follows:
Figure 76
The following table provides a description of the components of the interface:
Position Type Description
A
LED
L Protection LED (alarm and trip)
B L Protection LED (pre-alarm)
C S Protection LED (alarm and trip)
D I Protection LED (trip)
E G Protection LED (alarm and trip)
F Power-on LED (trip unit powered and on)
G
Protections:
thresholds
L Protection dip-switch (threshold I1)
H S Protection dip-switch (threshold I2)
I I Protection dip-switch (threshold I3)
L G Protection dip-switch (threshold I4)
M
Protections: times
L Protection dip-switch (time t1)
N S Protection dip-switch (time t2 and type of curve)
O G Protection dip-switch (time t4 and type of curve)
P Settings Neutral and frequency dip-switch
Q
Test
Test pushbutton
R Test connector
IMPORTANT: the figure above refers to an Ekip Dip, LSIG version. In the case of Ekip Dip
LI or LSI versions, LEDs and dip-switches related only to the protections present are
available.
To Next Page
Loading...
