ABB SACE Emax 2 - Changing Parameters and Commands

To Next Page

To Previous Page

ABB | SACE Emax 2

Ekip Touch - Interface and menus

3 - Changing parameters and commands

Changing parameters

Comply with the following procedure to change one or more parameters:

IMPORTANT: parameters can be changed with Trip unit in the Local mode and in the

absence of timing alarms

1. select parameter and enter PIN, if required

2. select new value from list or with the aid of page commands

3. select Confirm command if present:

Figure 4

4. When the new value has been selected/confirmed, the menu of the parameter is accessed automatically,

the changed item presents the new value in light blue and a tick to confirm:

Figure 5

Now proceed by confirming the programming (Step 5) or access other parameters

and make further changes (Step 1).

5. Select the arrow at the top left to access the top menu until the

Programming

page appears:

Figure 6

6. Various commands are enabled in the programming page:

•

Confirm

to validate the new parameters and conclude the programming procedure

•

Abort

to interrupt the save data process

•

Modify

to go back to the menus and change the parameter or others

Figure 7

Other manuals for ABB SACE Emax 2