ABB SACE Emax E2.2 - Environmental Conditions; Installation

ABB | SACE Emax 2
Management operations | 4 - Environmental conditions23 | © 2019 ABB | 1SDH001000R0002 - ECN000109166 - Rev. D
4 - Environmental conditions
Details related to this chapter are available in the manual 1SDH001330R1002 (Emax 2 engineering manual)
available on the website ABB library.
5 - Installation
Warnings and precautions
before the installation
The following warnings and precautions must be respected before installing the circuit-breaker in the
switchgear
WARNING!
• Disconnect the power from the circuit-breaker (power circuit and auxiliary circuits)
• Make sure the circuit-breaker is disconnected from all sources of energy
• Switch the circuit-breaker to the open position with springs discharged
NOTE: The trained personnel in charge of handling and lifting must use appropriate safety
equipment.
Mounting of the fixed circuit-
breaker
Fix the circuit-breaker to a horizontal surface using 4 x M10 screws. See Figure 54.
Figure 54
WARNING! Emax E2.2-E4.2-E6.2 circuit breakers can only be installed in vertical
position
Mounting anti-insertion locks
Before installing the fixed part, it is necessary to fit the lock that prevents the insertion of circuit-breakers with
different electrical characteristics from the fixed part. See Figure 55.
Information on the assembly is available on the website http://www.abb.com/abblibrary/DownloadCenter/, in
particular with the kit sheet 1SDH001000R0701.
E
2
.
2
N
-
B
-
S
E2
.
2
H
0
2
0
8
1
0
1
2
1
6 2
0
2
5
0
8
1
0
1
2
1
6
2
0
2
5
LEFT
M
A
T
C
H
A
L
S
O
T
H
E
R
I
G
H
T
S
I
D
E
Figure 55