ABB SACE Emax E2.2 - 6 - Menu

ABB | SACE Emax 2
Ekip Touch - Interface and menus
4 - Menu
49 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Settings Menu
Menu Submenus Description and parameters Page
Bluetooth Low
Energy
Enable
(5)
Enabling and configuration of
Bluetooth Low Energy communication
131
-
Circuit Breaker
Configuration
Phase number selection 130
Hardware Trip Protection activation command
64
T Protection Protection activation command
Neutral Protection
(2)
Enable , Neutral threshold
Earth protection
(7)
External toroid configuration 132
Installation Installation of modules 50
Main Frequency - Grid frequency configuration 130
Phase Sequence - Phase sequence configuration 67
Modules
Local/Remote
Parameter writing configuration
131
Local Bus Configuration of local bus presence
Modul x
(3)
Details in chapters of each module
Functions Switch On LOCAL , Signalling RESET
Monitor time
- Measuring range configuration 115
Test Bus - Test bus activation 133
Power Controller
(4)
Enable
(5)
Function enabling and parameters:
see details in dedicated chapter
142
-
Load Shedding
(4)
Enable
(5)
Function enabling and parameters:
see details in dedicated chapter
143
-
Network Analyzer
(6)
Enable
(5)
Function enabling and parameters:
see details in dedicated chapter
123
-
Datalogger
(6)
Enable
(5)
Function enabling and parameters:
see details in dedicated chapter
121
-
Dual Set
(6)
Enable
(5)
Function enabling and parameters:
see details in dedicated chapter
82
Default set
System
Date Configuration of unit date
133
Time Configuration of unit time
Language Configuration of menu language
New PIN PIN Configuration
View -
Representation parameters of menus
and measurements: see details in
dedicated chapter
133
Functions
YO Command
Function , Delay 92
YC Command
Maintenance Alarms Activation of maintenance signals 116
(1)
with CB in 3P configuration
(2)
available with CB in 4P or 3P with neutral configuration
(3)
the menu populates with the list of accessory modules detected by the unit with Local Bus
activated and in the envisaged connection and supply conditions
(4)
available if the function has been installed in the Trip unit
(5)
additions are only made to the list of the specific submenu when the function is enabled (=On)
(6)
available if provided for by Trip unit model or if relative SW package has been activated
(7)
available with LSIG versions