ABB SACE PR212/MP - Parameters

ABB SACE SACE PR010/T RH0029002 L2551 41/67
67
Where the arrows indicate which elements of the ALARM 1 block are selected.
The buttons  and  are used to display the previous/next screen and the buttons  and  to
activate/deactivate the selected element (the arrow next to the element is shown/removed)
There are 18 blocks, each of which is made up of eight elements and is displayed in three
consecutive screens; up to 8 elements may be activated for each block.
On the last screen of each block it is possible to define the AND/OR logic applied to the selected
elements and the minimum release activation time.
13.6.2 Parameters
The protection parameters are divided into:
1. L protection
2. S protection
3. I protection
4. G protection
For example, selecting:
enters the screen that displays the parameters of protection L and the following screen appears:
Pressing the ENTER key launches editing mode (the cursor starts blinking); the buttons  and 
are used to position the cursor on the desired parameter and the buttons  and  to change the
value of the parameters in the allowed range.
Key to be pressed Item selected
1 Operation mode
x PR121/P
4 Config./Parameters
2 Parameters
1 Protection L
ENTER
L prot t=k/i2 [...]
Threshold: x.xx In
Time: x.xx s
Thermal mem: ON [OFF]