15
Data Code Data Values
direct.
Remotely set start value for stage U> S31 R 0.8...1.6 x U
n
Remotely set operate time or time S32 R 0.05...100 s or
multiplier for stage U> 0.05...1.00
Remotely set start value for stage U< S33 R 0.4...1.2 x U
n
Remotely set operate time for stage U< S34 R 1...120 s
Remotely set checksum of S35 R 0...255
switchgroup SG1
Max. voltage measured when V1 R 0...9.99 x U
n
stage U> started
Max. voltage measured after resetting V2 R 0...9.99 x U
n
Min. voltage measured when V3 R 0...9.99 x U
n
stage U< started
Min. voltage measured after resetting V4 R 0...9.99 x U
n
Number of starts of overvoltage stage V5 R 0...255
Number of starts of undervoltage stage V6 R 0...255
Duration of the latest start V7 R 0...100%
event of stage U>
Duration of the latest start V8 R 0...100%
event of stage U<
Resetting of output relays and V101 W 1 = output relays and operation
operation indicators indicators reset
Resetting of output relays, operation V102 W 1 = output relays, operation
indicators and erasing of recorded data indicators reset and registers
simultaneously (codes V1…V8) erased
Remote control of settings V150 R, W 0 = setting with knobs
S11...S15 activated
1 = remote settings
S31...S35 activated
Event mask word V155 R, W 0...255, see section
"Event codes"
Manual reset or self-reset mode of V156 R, W 0…15, see section
operation of the LED indicators (SG2) "Selector switches"
Programming push-buttons (SG3) V157 R, W 0…1, see section
"Selector switches"
Opening of password for V160 W 1...999
remote settings
Changing or closing of password V161 W 0...999
for remote settings
Activation of self-supervision function V165 W 1 = self-supervision output is
activated and IRF indicator
turns on in about 5 seconds,
whereafter the self-super-
vision system and the IRF
indicator reset
Internal fault code V169 R 0…255
Data communication address V200 W 1...254
of the relay module
Program version V205 R 072_
To Next Page
Loading...
