12 TEIP11, TEIP11-PS I/P SIGNAL CONVERTER | OI/TEIP11/TEIP11-PS-EN REV. M
… 6 Installation
… Mounting
Aluminum / stainless steel field mount housing
The sturdy housing unit can be installed outdoors without
protection.
1 Terminal for signal input
(covered)
2 Cable entry
3 Supply air connection
4 Output (covered)
Figure 6: Aluminum / stainless steel field mount housing
Installation instructions
Position the housing so that the cable gland is facing
downwards or sideways, to prevent humidity from penetrating
the device.
Accessories
A stainless steel mounting bracket is available as an accessory
for installation.
The mounting bracket is available in two designs:
• For wall mounting only
• Universal for wall or 2 in pipe mounting
Field mount housing as a mounting module for OEM
applications (TEIP11)
1 Terminal for signal input
(covered)
2 Cable entry
3 Supply air connection
4 Output (covered)
Figure 7: Aluminum / stainless steel field mount housing
Installation instructions
Position the housing so that the cable gland is facing
downwards or sideways, to prevent humidity from penetrating
the device.
Accessories
A stainless steel mounting bracket is available as an accessory
for installation.
The mounting bracket is available in two designs:
• For wall mounting only
• Universal for wall or 2 in pipe mounting
Plastic field mount housing
The plastic housing is suitable for installation on-site.
1 Output (covered)
2 Supply air connection
3 Combustible gas discharge line,
crimp connection, 6 mm (0.24 in)
4 Cable entry
5 Terminal for signal input
(covered)
Figure 8: Plastic field mount housing
Installation instructions
Units can be mounted on walls or vertically on a 2 in pipe.
The connections for the input and output signals should face
downwards, to prevent humidity from penetrating the device.
To Next Page
Loading...
