ABB TEIP11 - Product Housing Designs; Control Room Housing for Rail Mounting; Control Room Housing for Block Mounting; Field Mount Housing Options

TEIP11, TEIP11-PS I/P SIGNAL CONVERTER | OI/TEIP11/TEIP11-PS-EN REV. M 9
Designs
1 Control room housing for rail
mounting
2 Control room housing unit for
block mounting
3 Plastic field mount housing
4 Aluminum or stainless steel field
mount housing
Figure 2: TEIP11-PS designs
Control room housing unit for rail mounting
The control room housing for rail mounting is the simplest and
lowest priced version of the I/P signal converter.
A mounting base that is compatible with all commercially
available EN rails is used for installation.
The housing unit with plastic cap has an IP 20 protection rating.
Control room housing unit for block mounting
The control room housing unit for block mounting enables you
to install a number of converters in a small space. This design
features central air supply via connection block and stop valves
in the air connectors of the integrated signal converter.
A maximum of 4 signal converters can be fitted on the
connection blocks required for block mounting. If necessary, 2 or
3 (or max. 4) connection blocks can be connected to each other
to create block units of 4-8-12-16 signal converters. Stop valves
allow you to mount or remove individual converters during
operation.
Field mount housing
The field mount housing is suited for installation on-site or in
open areas. The housing can be made from plastic with IP rating
IP 54, from aluminum with IP rating IP 65 and from stainless
steel with IP rating IP 65. The housing is suited for wall mounting
and for 2 in pipe mounting.