—
ABB MEASUREMENT & ANALYTICS | OPERATING INSTRUCTION
TEIP11, TEIP11-PS
I/P signal converter
—
ABB Limited
Measurement & Analytics
Howard Road, St. Neots
Cambridgeshire, PE19 8EU
UK
Tel: +44 (0)870 600 6122
Fax: +44 (0)1480 213 339
Email: enquiries.mp.uk@gb.abb.com
ABB Automation Products GmbH
Measurement & Analytics
Schillerstr. 72
32425 Minden
Germany
Tel: +49 571 830-0
Fax: +49 571 830-1806
abb.com/positioners
ABB Inc.
Measurement & Analytics
125 E. County Line Road
Warminster, PA 18974
USA
Tel: +1 215 674 6000
Fax: +1 215 674 7183
OI/TEIP11/TEIP11-PS-EN Rev. M 08.2018
—
TEIP11
TEIP11-PS
Introduction
I/P signal converter for controlling pneumatic
actuators or conventional positioners for valve
positioning.
Additional Information
Additional documentation on TEIP11, TEIP11-PS is
available for download free of charge at
www.abb.com/positioners.
Alternatively simply scan this code:
—
We reserve the right to make technical changes or modify the contents of this document without prior
notice. With regard to purchase orders, the agreed particulars shall prevail.
ABB does not accept any responsibility whatsoever for potential errors or possible lack of information in
this document.
We reserve all rights in this document and in the subject matter and illustrations contained therein. Any
reproduction, disclosure to third parties or utilization of its contents – in whole or in parts – is forbidden
without prior written consent of ABB.
Copyright© 2018 ABB
All rights reserved 3KXE311001R4201
To Previous Page
