Operation Manual / TPL73-B.. - 85-B11/ -B12
8 Disassembly and assembly / 8.9 Installing cartridge group
© Copyright 2018 . All rights reserved. HZTL2480_EN Revision D July 2018
Fitting compressor casing
internal part
u Fit the oil drain screw (42245).
u Attach the lifting device (90190/90195) to the front of the flange of
the compressor casing internal part (76000).
u Fit O-ring (76040).
u Remove the support angle (90025).
u Fit four guide studs (90320).
u Carefully position the compressor casing internal part (76000) with
wall insert and diffuser over the guide studs, move it in and then re-
move the lifting device (90190/90195).
u Move in the compressor casing internal part as far as it will go.
u Remove the guide studs (90320) and fit the studs (74026/74029).
u Use studs [10x 74029 and 2x 74026 (each screwed in at top and bot-
tom)].
Page 119 / 151
To Next Page
Loading...
