58 UNIGEAR ZS2 INSTALLATION, OPERATION AND MAINTAINANCE INSTRUCTION MANUAL
UniGear ZS2 switchgears are produced in
compliance with the requirements of
international standards for quality
management system and environmental
management system. The level of excellence
achieved in these fields is documented by quality
certificates according to ISO 9001 and by the
EMS according to ISO 14001.
End of life of product.
• The ABB company is committed to comply
with the relevant legal and other requirements
for environment protection according to the
ISO 140001 standard.
• The duty of the company is to facilitate
subsequent recycling or disposal at the end of
product life
During disposal of product, it is always necessary
to act in according with local legal requirements
in force. The following methods of disposal are
possible:
• Disposal can either be carried out thermally in
an incineration plant or by storing on a waste
site.
—
10. Product quality and
environmental protection
Raw material Recommended method of disposal
Metal material (Fe, Cu, Al, Ag, Zn, W, others) Separation and recycling
Thermoplasts Recycling or disposal
Epoxy resin Separation of metal material and the disposal of rest
Rubber Disposal
SF6 gas Discharging from equipment or further recycling or disposal.
Packing material - wood Recycling or disposal
Packing material - foil Recycling or disposal
To Next Page
Loading...
