- 32 -
000473AG
Remote Firmware Update Function
The inverter rmware can be updated remotely using the accessory
boards which are compatible with the inverter. For further information,
refer to the website or contact ABB.
Stand by Mode
This functionality allows the inverter to remain on and connected to the
grid even with an input voltage of less than the minimum required for
operation. It is particularly useful in conditions of low irradiation and with
passing shadowed areas that would cause continuous connections and
disconnections to the grid. Instead, with this functionality, the inverter
starts to deliver power as soon as the input voltage exceeds the minimum
for re-activation without having to repeat the grid connection sequence.
The time in which the inverter remains in this state can be set by ac-
cessing the Settings menu and activating the time for Input Undervoltage
Protection (TprotUV). If within the set time the conditions to export grid
power do not reoccur, the inverter disconnects from the grid.
Скачано с сайта интернет магазина https://axiomplus.com.ua/
To Next Page
Loading...
