AbbiDot T50 - How LED Light Works; How to Use the Test Light Tool; Step 5. Collar Fitting

9
Test Light Instructions
1. Make sure the collar is off your dog.
2. Turn on the collar.
3. Hold the test light’s contacts against the contact
points of the collar.
4. Press the Smulaon Buon — the test light tool will
light up. Its brightness will increase or decrease
depending on the level of smulaon you are using.
How LED light works?
Do not shave your pet’s neck as this may increase
the risk of skin irritaon. Your dog shouldn’t wear
the collar for more than 8 hours per day.
Caution:
When placing the collar on your dog, make sure it fits properly and the
contact points are pressed firmly against the dog’s skin. If the collar is
fied too loosely, it may move during the training process and the
contact points may hurt the dog’s skin.
The collar should also not be fied too ghtly: you should be able to
place a finger between the dog’s neck and the training collar. If placed
too ghtly, the collar may cause breathing difficules for your dog.
STEP 5. COLLAR FITTING
When you can't find your dog in the dark, you
can find it by lighng the LED light.