Abbott FreeStyle Navigator - Setting Projected Alarms

OVER
Steps Do This
5. Set, review, or change your
Projected Low glucose alarm.
a. Select Projected Low from the Alarms menu.
•UsetheUP/DOWNArrowbuttonstohighlight
Projected Low.
•PresstheRIGHT Option button to select
Projected Low.
b. Review or change your settings.
•PresstheLEFT Option button (Next) to move
from one eld to the next.
•UsetheUP/DOWNArrowbuttonstochange
the setting in any eld.
•PresstheRIGHT Option button (Set) to accept the
settings and return to the Alarms menu.
Note: e receiver will respond with a brief sample
of the alarm you selected.
c. Decide what to do next.
•Youaresetting,reviewing,orchanging
all alarms.
Continue to the next step.
•Youarenishedsetting,reviewing,and
changing alarms.
Go to Step 11.
If en
Decide what settings you want:
• Alarmonoro.
• Sensitivity.
• Alarmtype(Setting).
– Low, medium, or high beep.
– Short, medium, or long
vibration.
If you want this much notice
before reaching your Low
glucose level:
en set the
Sensitivity to:
•Maximumdetection(most
alarms, approximately 30
minutes in advance of events)
•Intermediatedetection
(intermediate alarms,
approximately 20 minutes in
advance of events)
•Lowdetection(fewestalarms,
approximately 10 minutes in
advance of events)
High
Medium
Low
Section 8 73
Set, Review, or Change the Alarm Settings
Alarm Settings 08:30A
Low Glucose (70)
High Glucose (275)
Projected Low (On)
Projected High (O)
Data Loss
Main Select
Alarm Settings 08:30A
Projected Low Glucose
ON
Sensitivity: Low
Setting: Medium Beep
Next Set