36
3
Insert the three black lines at the end of
the test strip into the strip port.
4
Push the test strip in until it stops.
The meter turns on automatically.
These items show on the display window, one
after the other:
•Display Check – Remember to make
sure that all items in the picture here
show on the display window (See
Chapter 1 for more information about
the Display Check).
•Time, month, and day (if set)
If date and time are not set, dashes will
show instead of numbers.
• LOT 45001 and the Apply Sample
symbols
and .
Note: CODE 75001 and
followed
by
and will appear if
performing a ketone control solution test.
Note: The LOT/CODE number shown on the display
window must match the LOT number for the box of
test strips you are using.
Control
Solution Testing
To Next Page
Loading...
