Abcon ProShip - Weighing Operations; Error Messages; Weighing Procedures

8 PROSHIP
®
WEIGHING
BEFORE WEIGHING
Wheneverpossible,pleaseallowthescaletowarmupforseveralsecondsafterrst
turning the power on so that the scale will function properly and accurately.
ERRORMESSAGES:
EEEE or Err-0 =Overload
, Lob or LoBatt  =LowBattery
WEIGHING PROCEDURES
1. PRESS[ON/OFF]TOTURNONTHESCALE:
When the power is turned on the display will count down from “999999” to “111111”
and then “0” appear on the display.
2. SELECTTHEWEIGHINGUNITWITH[UNIT]:
Press [UNIT] to select a weighing unit “kg”, “lb”.Oncetheunithasbeenselected,the
 selectedunitwillbedisplayednexttotheweightvalue.
3. STARTWEIGHING:
If you do not use a container for weighing:
 • Verifythereadingis“0”. If not, press [ZERO] to display “0”.
 • Placetheitemstobeweighedontheplatform.
If you use a container for weighing:
 • Placeanemptycontainerontheplatform.
 • Waitforthestabilityweighingtobedisplayedandpress[ZERO].
 • Placetheobjectstobeweighedinthecontainer.