Abeeway Micro Tracker - Page 15

Micro Tracker Reference Guide FW 1.7 V1.1
Page 15 of 39
11th october 2018
Restricted distribution
The NOTIFICATION message associated to this command is shown below.
Reading parameter value response
Byte 0
Byte 1
Byte 2-5
Status
• 0x00: success
• 0x01: Invalid payload
• 0x02: Invalid Parameter ID
Parameter ID
Parameter Value.
Please check the status before taking
this value in consideration
Example:
To read the value of parameter ID 0x05. The write command 0x0005 should be sent.
A notification will be received in response, containing the parameter value: 0x000500000001.
4.3.7 Tracker Operational modes
4.3.7.1 Introduction
The Client application can change and retrieve the tracker operational mode by sending either a WRITE_REQ
or a READ_REQ using the following Abeeway primary service.
Abeeway Primary Service (UUID 00008A45-1212-efde-1523-785feabcd123)
Operational mode Characteristic
UUID
Permission
00002741-1212-efde-1523-785feabcd123
WRITE_REQ
READ
The Client application should first discover the Abeeway Primary service (UUID: 00008A45-1212-efde-1523-
785feabcd123). This service supports a writable and notifiable characteristic called Operational mode
Characteristic with UUID: 00002741-1212-efde-1523-785feabcd123.
4.3.7.2 Change the operational mode
The Client application can change the operational mode by sending a write request (WRITE_REQ) containing
the new operational mode value.