Hardware Setup 2-17
(13). Serial ATA Connectors
These connectors are provided to attach one Serial ATA device at each channel via Serial ATA cable.
For more information on how to configure the function mode for SATA1 and SATA2, please refer to the
item “Serial ATA 1 Mode” and “Serial ATA 2 Mode” in the BIOS menu of “OnChip IDE Device”.
NOTE: The Serial ATA controller only supports Ultra DMA/ATA100 or higher hard drive. Do not use
hard drives under this specification, or it won’t work.
User’s Manual
To Next Page
Loading...
