aboni HydroTracer HT3 User Manual

Selection Menus & Status Display
31
4.4 Status Display & Information field
In the main menu (cf. „2.1 The procedure step by step“ field (C) and (D)) you get information
about the connection of the HydroTracer (and the serial scale), as well as a status message
about the HydroTracer itself.
If the HydroTracer and a serial
balance are connected, you will
receive this information in the
Information field (C) .
If no scale is connected, only the
HydroTracer with the COM port
number is displayed.
The field (D) gives you information
about the operating status of the
HydroTracer.
Three status messages are possible here:
1. "Ready" – the HydroTracer is ready for a measurement
2. “Warm Up" – the HydroTracer is not yet on stand-by temperature and is warmed up
3. “Systemtest” – the HydroTracer performs an internal system test. This happens every
time after switching on the instrument.
4. "Cool Down" – the HydroTracer is currently cooling down to the stand-by temperature
of 50 °c
5. “Test Mode” – the HydroTracer is currently measuring
6. “Error” – the HydroTracer has detected an error

aboni HydroTracer HT3 Specifications

General

Brand	aboni
Model	HydroTracer HT3
Category	Measuring Instruments
Language	English