70
English
18. PRACTICE ACTIVATION
To carry out test activation, remove the inflator from your switched-off system (handle in OFF position and LEDs
no longer flashing). When you turn the handle to the ON position, the top LED flashes red. The bottom LED
always shows the group status.
Individual mode
The top LED flashes red. When you pull the handle, the top LED lights up
white for 3 seconds to show you that activation was successful. The LED
flashes red again after the simulation. The system is ready for another
practice activation.
Group mode
The top LED flashes red and the bottom LED flashes blue slowly.
When you pull on the handle, the top and bottom LEDs light up white/
blue for 3 seconds to simulate successful activation. Then the top LED
flashes red again and the bottom LED flashes blue. The system is ready
for another test activation.
To Next Page
Loading...
