Abus AirSecure CO2WM110 User Manual

– 20 –
– 21 –
Installation
GB
ø 5 mm
the detector is active
5. Keep water and other liquids away from the detector as it is not waterproof
6. Do not insert sharp, ammable or metallic objects into the air inlets as this
can result in an electric shock or burns
7. Power should be supplied via the micro-USB cable and the AC adapter; the
internal, built-in battery is only used for emergency power supply
8. The detector can be mounted on the wall or set up with the table base
9. If the device has been dropped or otherwise damaged, it may not be used
anymore
10. The device must not be opened or repaired. Failure to comply will invalidate
the warranty
Wall installation:
• mark the drill holes horizontally with the enclosed
template and a spirit level
• drill the holes with a ø 5 mm drill bit. Impor-
tant: do not damage any cables when drilling
and keep the detector away from drilling dust!
• push the plastic dowels into the drilled holes
and screw in the screws until the screw heads
protrude approx. 5 mm
68 mm
Kohlendioxidmelder_CO2WM110_Manual_3.indd 21Kohlendioxidmelder_CO2WM110_Manual_3.indd 21 04.03.2021 16:46:4404.03.2021 16:46:44

Abus AirSecure CO2WM110 Specifications

General

Best uses	Home, Office
Audible alarm(s)	Yes
Interconnectable	-
Detected gas types	Carbon dioxide (CO2)
Display type	OLED
Product color	Black, White
Battery type	Built-in battery
Battery voltage	3.7 V
AC input voltage	100 - 240 V
Power source type	AC, Battery
Quantity per pack	1 pc(s)
Operating temperature (T-T)	-10 - 40 °C
Operating relative humidity (H-H)	0 - 95 %

Weight and Dimensions

Depth	96.5 mm
Width	96 mm
Height	26 mm
Weight	273 g