Abus AirSecure CO2WM110 - Operating Buttons and Stand Mounting; Stand Setup Instructions; Device Control Buttons

– 22 –
– 23 –
Installation, Operating buttons and display symbols
1. Power on/o with a long press (approx. 3 seconds)
2. Mute
3. Switch on display with a short press
4. In setup mode: Move one position to the right
5. In setup mode: Increase value(s) by one
6. In the normal state: Change pages
1. Enter the setup mode by pressing and holding (approx. 3 seconds)
2. Switch the display o/on by pressing briey
3. Save and exit settings by pressing briey
4. Mute
1. In setup mode: Move one position to the le
2. In setup mode: Decrease value by one
3. In the normal state: Change pages
4. Switch on display with a short press
5. Mute
Operating buttons
Stand mounting:
• fold out the table base on the underside of the housing and place the
detector on a at and dust-free surface
• ensure that the detector is stable and that no objects interfere with the
penetration of CO
2
into the detector
Kohlendioxidmelder_CO2WM110_Manual_3.indd 22Kohlendioxidmelder_CO2WM110_Manual_3.indd 22 04.03.2021 16:46:4404.03.2021 16:46:44