Abus CFA3010 - Tips for Troubleshooting

46

Tips for troubleshooting
 Cause Solution


locking process and a sustained
acoustic signal sounds
The door was not closed
during the second part of the
teach-in process
- Repeat the teach-in



service (5.6) and a sustained
acoustic signal sounds
- The door is not closed during
operation so the drive pushes
the door bolt against the
door edge
- At least one battery is inser-
ted the wrong way round
- The locking mechanism is

incorrectly
- Close the door and repeat
operation
- Open the battery com-
partment and check the
-
sert the batteries correctly

- Set the door correctly

mechanism
An acoustic signal sounds be-
fore every rotational movement
by the drive
The batteries are dead 
Before opening the door, the
drive carries out a reference
movement
The door has since been

a key or the drive’s handwheel
has been turned
No action required.
A reference movement is
necessary to identify the cor-

has been manually turned
using a key from outside or
the handwheel from inside.
2 x
P
S
8
8
AA
+
AA
+
6.1 a 6.1 c
-
A
B
U
S
6.1 e
6.2
6.3
6.1 d
7.
CFA3010 Z-Wave6.indd 46 09.01.2019 16:20:15