27
1.
1.
Possible uses and important information
Please also refer to the instructions for your primary Z-Wave-Controller!
SKU: ABUS CFA3010
Quickstart
This is a secure Door Lock for
Europe. To run this device please
insert fresh 4 * AA batteries. Please
make sure the batteries are fully
charged. The quickstart can only
take place if the door lock has been
installed and the road and motor
drive has been carried out (see
page 34-42). Attention: the delivery
status of the Z-Wave lock drive is
the S2 security standard. Please
contact the manufacturer of your
Z-Wave-Controller for information
on the security standard used (S0
or S2) an set this in advance on
the drive in accordance with your
Z-Wave-Controller.
First, start the Inclusion process
at your primary Z-Wave-Controller.
Then press the two arrow keys on
the management mode. Clicking
at the same time. This indicates that
the device is ready for inclusion. If
the inclusion is successful, the right
The inclusion mode is terminated.
Pressing the ‘Open‘ key also ends
the management mode. Please
observe the instructions on the
central controller when embedding.
The device also supports Smart
Start. Please scan the QR code on
the cover or on the device and your
controller will add the device auto-
matically when powered up.
What is Z-Wave?
Z-Wave is the international wireless
protocol for communication in the
for use in in the region mentioned
in the Quickstart section. (For more
information about frequency regu-
lations please refer to the frequency
-
Z-Wave ensures a reliable com-
message (two-way communication)
and every mains powered node can
act as a repeater for other nodes
(meshed network) in case the recei-
ver is not in direct wireless range of
the transmitter.
Z-Wave device can be used together
with any other certified Z-Wave
device regardless of brand and
origin as long as both are suited for
the same frequency range.
If a device supports secure com-
munication it will communicate
with other devices secure as long as
this device provides the same or a
higher level of security. Otherwise
it will automatically turn into a
lower level of security to maintain
backward compatibility.
A secure connection to the device
according to security standard S2 re-
quires the network key type „access
device“.
For more information about Z-Wave
technology, devices, white papers
etc. please refer to www.z-wave.
info.
Product Description
lock actuator is system designed for
-
wards to provide motorised locking
and unlocking functions. The door
can be electronically operated using
local buttons and any Z-Wave device
capable to control door locks. For
the wireless door lock actuator to
work, the cylinder must project 7-12
mm on the inside of the door (plus
-
lar). Because the actuator operates
CFA3010 Z-Wave6.indd 27 09.01.2019 16:19:48
To Next Page
Loading...
Need help?
General
