Why is my Abus DVR showing no image?
If your Abus DVR displays no image, it could be due to several reasons. First, ensure that your screen is set to receive input from the DVR by selecting the correct video input mode. Second, verify that the video cable is securely connected. Lastly, check that the connected monitor is switched on.
What to do if my Abus TVVR30004 DVR has no power?
If your Abus DVR has no power, check these items: ensure the mains cable is securely connected to the socket; verify the power switch is turned to the ON position; and test the power socket with another device to confirm it is working.
Why is my Abus TVVR30004 remote control not working?
If the remote control for your Abus DVR isn't working, try these steps: * Replace the batteries, ensuring they are inserted with the correct polarity. * Make sure you are within 7 meters of the device and pointing the remote at the sensor. * Remove any obstructions between the remote and the DVR. * Switch off any strong fluorescent lighting nearby.
What to do if Abus DVR's HDD is not working?
If the HDD in your Abus DVR is not working, first ensure that all connection cables are securely connected. If the problem persists, the HDD may be defective or incompatible. In this case, replace it with a recommended HDD.
Why is there no sound from my Abus DVR?
If there is no sound from your Abus DVR, check that the audio cables are securely connected. Also, verify that the devices connected via the audio cables are switched on. If the issue continues, the audio connection cable might be damaged and require replacement.
How to fix Abus TVVR30004 DVR when recording is not possible?
If your Abus DVR is unable to record, it may be due to the absence of an HDD or because the HDD hasn't been initialized. You should install and initialize the HDD.
What to do if Abus DVR suddenly deactivates?
If your Abus DVR suddenly deactivates, it might be overheating. Clean the device and ensure there are no obstructions blocking the ventilation area.
Why is network access not possible on my Abus DVR?
If network access is not possible on your Abus DVR, ensure the network cable is securely connected. Also, verify that your network settings (DHCP, IP address, etc.) are correct. If needed, check the network configuration and correct it.
Why is the USB port not working on my Abus DVR?
If the USB port on your Abus DVR is not working, the connected device might not be supported. Try connecting a compatible USB 2.0 medium directly, without using a USB hub.
General| Video Inputs | 4 |
|---|---|
| Recording Resolution | 1080p |
| Compression | H.264 |
| Channels | 4 |
| Remote Viewing | Yes |
| Motion Detection | Yes |
| Power Supply | 12V DC |
| Video Outputs | 1 HDMI, 1 VGA |
| Audio Inputs | 1 RCA |
| Audio Outputs | 1 RCA |
| Hard Drive Support | 1 SATA up to 6TB |
| Network Interface | RJ45 |
| USB Ports | 2 x USB 2.0 |
| Operating Temperature | -10°C to +55°C |
To Next Page
