Need help?Do you have a question about the Abus TVVR33004 and is the answer not in the manual?
General| Model | TVVR33004 |
|---|---|
| Channels | 4 |
| Video Compression | H.264 |
| Video Inputs | 4 x BNC |
| Audio Outputs | 1 x RCA |
| Hard Drive Support | 1 x SATA HDD |
| USB Ports | 2 x USB 2.0 |
| Resolution | 1920 x 1080 |
| Motion Detection | Yes |
| Operating Temperature | -10°C to +55°C |
| Storage Capacity | Up to 6TB |
| Network Interface | RJ45 |
| Power Supply | 12V DC |
| Video Outputs | 1 x HDMI, 1 x VGA |
| Audio Inputs | 1 x RCA |
| Recording Resolution | 1080p |
| Remote Viewing | Yes |
Explains the meaning of symbols used in the manual and on the device.
Specifies the purpose for which the device is designed and intended for use.
Provides general safety instructions to be observed before first use.
Instructions for connecting the device to the mains power supply.
Guidance on suitable locations and environmental conditions for device operation.
Precautions against overloading sockets and protecting against overvoltage.
Safety guidelines for handling and connecting cables.
Instructions for maintaining and cleaning the device.
Instructions for safely starting the device for the first time.
Explains how to use a USB mouse to navigate and control the device.
Preparations required before setting up the device, including safety.
Instructions for connecting cameras, monitor, network, and mouse.
Guidance on connecting power and the initial device startup process.
Overview of the initial configuration steps within the setup wizard.
Procedures for safely shutting down, locking, or rebooting the device.
Guides through basic system settings for recording and monitoring readiness.
Instructions for setting up the administrator account and password.
Setting the correct time zone, date, and time for the system.
Configuration of network parameters like IP address, DHCP, and DDNS.
Steps for initializing the hard disk drive for recording.
Configuration of recording settings for individual cameras.
Procedure for searching and adding network cameras to the system.
Manages general device settings like language, resolution, and date/time.
Essential settings for controlling the device remotely via a network.
Configures how multiple cameras are displayed simultaneously in live view.
Configures motion detection zones, sensitivity, and activation.
Defines recording times and triggers (e.g., continuous, motion detection).
Sets recording types and schedules for individual cameras.
Configures quality settings for main and substream video.
Steps for installing a 2.5" S-ATA hard disk drive.
Process for initializing the HDD so it can be recognized and used.
Instructions for starting and stopping manual video recording.
Identifies common faults and their solutions for device troubleshooting.
To Next Page
