Abus TVVR33004 - Network Detection Tab

Maintenance
120
Network Detection tab
Under "Network Delay, Packet Loss Test", you can check
the connection to another device, such as a computer
(‘pinging’). Enter the network address of the device to be
checked (e.g. 192.168.0.25) and click on Test.
Information on two parameters will appear:
Parameter
Setting
Average
delay
The time the pinged device needs to
reply.
Packet loss
rate:
Displays the percentage of packets
that were not transmitted.
Note
If the packet loss rate is high, we recommend that
the "Network Delay, Packet Loss Test" is
repeated.
Note
If the packet loss rate is still high, you should
check that the network cables are correct and not
damaged.
The higher the packet loss rate, the poorer the
connection between the pinged device and the
recorder.
Under "Network Packet Export", the settings of the
individual connections can be exported according to the
setting of the connection.
1. For "Device Name", select a storage medium to save
the settings to.
2. Click on Export.
After the progress display finishes and initialisation is
successful, an information window will appear. Close
it by clicking on OK.
Click on Status to display the status of the LAN
connections (connected/not connected).
 Click on Net Detect to change your network settings.
Note
This view allows for the analysis of network and
performance problems with the recorder.
Network Stat. tab
The bandwidth used by the device is displayed under this
tab.
You can refresh the data by clicking on Refresh.