What to do if my Abus DVR has no image?
If your Abus DVR shows no image, ensure the screen is set to the correct video input mode until you see the recorder's image. Also, check that the video cable is securely connected and the monitor is switched on.
Why is my Abus DVR not turning on?
If your Abus DVR has no power, make sure the mains cable is securely connected to the socket. Check that the power switch is turned ON. Try using another device on the same power socket to ensure the socket is working.
How to fix an Abus DVR remote control that is not working?
If the remote control for your Abus DVR isn't working, replace the batteries, ensuring they're inserted with the correct polarity. Also, make sure you are within 7 meters of the device and that there are no obstructions blocking the signal. If there's strong fluorescent lighting nearby, try switching it off.
What to do if the HDD in my Abus DVR is not working?
If your Abus DVR's HDD is not working, first ensure the connection cables are securely connected. If the problem persists, the HDD might be defective or incompatible; consider replacing it with a recommended HDD.
Why is recording not possible on my Abus DVR?
If you cannot record with your Abus DVR, it may be because no HDD is installed or the installed HDD has not been initialized. Install and initialize the HDD to resolve this.
How to troubleshoot no sound on Abus DVR?
If there is no sound from your Abus DVR, check that the audio cables are securely connected. Ensure that any devices connected via the audio cables are switched on. If the problem persists, the audio connection cable may be damaged and need replacing.
How to fix network access on an Abus DVR?
If you can't access the network with your Abus DVR, ensure the network cable is properly connected. Verify that the network settings (DHCP, IP address, etc.) are correct and adjust them if necessary; refer to page 96 for guidance.
Why does my Abus DVR suddenly deactivate?
If your Abus DVR suddenly deactivates, it could be due to high internal temperature. Clean the device and remove any obstructions from the ventilation area.
What to do if the USB port on my Abus DVR is not working?
If the USB port on your Abus DVR is not working, the connected device might not be supported. Try connecting a compatible USB medium (USB 2.0). Also, if you're using a USB hub, connect the USB medium directly to the DVR instead.
General| Model | TVVR60011 |
|---|---|
| Type | DVR |
| Video Outputs | 1 |
| Audio Outputs | 1 |
| Compression Format | H.264 |
| Network Connectivity | Ethernet |
| Remote Access | Yes (via mobile app and web browser) |
| USB Ports | 2 |
To Next Page
