Need help?Do you have a question about the AC Infinity AIRTITAN T3 and is the answer not in the manual?
General| Brand | AC Infinity |
|---|---|
| Model | AIRTITAN T3 |
| Category | Fan |
| Language | English |
Drill holes, install anchors, and secure the unit to brick or block with screws.
Secure the mounting frame to the surface using the included wood screws.
Connect fan to S-Series controller via UIS extension cord and plug into power outlet.
Connect fan to controller, plug in sensor probe, and keep probe cord away from ballast.
Plug fan power cord into outlet and use tie mounts for cord management.
Plug thermal probe into fan unit and plug fan's power cord into an AC power outlet.
Adjust fan speed from 0-10 using a single button on the controller.
Turn fan OFF by holding the button for 4 seconds; press again to turn ON.
Cycles through OFF, ON, AUTO, TIMER, CYCLE, and SCHEDULE modes.
Sets minimum fan speed for OFF mode and other triggered modes.
Sets maximum fan speed for ON mode and other triggered modes.
Sets a high temperature threshold to activate devices based on ambient temperature.
Sets a low temperature threshold to activate devices based on ambient temperature.
Sets a high humidity threshold to activate devices based on ambient humidity.
Sets a low humidity threshold to activate devices based on ambient humidity.
Configures countdown timers for turning devices ON or OFF.
Sets ON and OFF durations for devices to cycle continuously.
Sets daily ON and OFF clock-time schedules for device activation.
Sets gradual level shifts based on temperature changes in AUTO mode.
Sets gradual level shifts based on humidity changes in AUTO mode.
Power on device, tap '+' tab, and select 'Smart Controllers' to begin pairing.
Check OFF Mode setting and triggers; ADVANCE programming may override.
Ensure ON Mode figure is not zero; check triggers and ADVANCE programming.
Adjust TRANSITION setting to smooth device level changes in AUTO mode.
Set OFF MODE for minimum speed, ON MODE for ramp-up speed.
To Next Page