AC Infinity CONTROLLER 75 User Manual

20
PROGRAMMING
AUTO MODE (LOW HUMIDITY TRIGGER)
Pressing the up or down button sets the low humidity
trigger. Your device will turn on if the probe’s reading
meets or falls below this threshold.
If the probe’s reading rises above this trigger point, your
device will turn off. This shut off point can be adjusted
using the buffer setting as shown on page 30.
This is typically used with devices like humidifiers
to help raise the humidity when it gets too dry. For
example, if you set a low humidity trigger of 50%, then
your device will activate when the humidity falls to 50%
or lower, and turn off when it rises above 50%. Products
shown here may still be in development.
Note that any of the four AUTO Mode triggers can activate at the same time, even if you are not viewing that
specific trigger. Turn off any triggers not in use by pressing the up and down buttons together while viewing that
trigger. Triggers may be delayed from turning off by your Buffer Settings, please see page 27 for more info.
LOW HUMIDITY
TRIGGER POINT
ON OFF
50
32 100
LESS HUMID MORE HUMID

AC Infinity CONTROLLER 75 Specifications

General

Brand	AC Infinity
Model	CONTROLLER 75
Category	Controller
Language	English