AC Infinity THERMAL TRIGGER User Manual

THERMAL TRIGGER CONTROLLER
To cycle through the options, press the round button. The first four options are to set
the trigger temperature. The fans will turn on, and the respective light will also be on,
when the probe’s temperature is at or above the temperature you chose. The fans will
shut off when the temperature is 4° F below the set temperature.
The next setting is the Always-On Mode which is shown when all four lights are on.
The fans will run continuously regardless of temperature. Pressing the round button
again will turn the fans and thermal trigger off.
If the lights are blinking, it means that it is not getting a signal from the thermal probe.
When this happens, the fans will run continuously regardless of temperature. Note
that the thermal trigger has a memory function so if there is a power outage, it will
remember its previous setting when power is available to it again.

AC Infinity THERMAL TRIGGER Specifications

General

Brand	AC Infinity
Model	THERMAL TRIGGER
Category	Controller
Language	English