To Next PageTo Next Page
Need help?Do you have a question about the Access IS LSR116 and is the answer not in the manual?
General| Reading Capability | 1D barcodes |
|---|---|
| Operating Voltage | 5 VDC |
| Weight | 150 g |
| Operating Temperature | 0°C to 50°C |
| Connectivity | USB |
| Scanning Technology | Laser |
| Supported Barcodes | UPC, EAN, Code 39, Code 128, Interleaved 2 of 5, Codabar |
| Power Supply | Via USB |
| Storage Temperature | -20°C to 60°C |
| Humidity | 5% to 95% (non-condensing) |
Lists product codes for serial and USB connected LSR116 devices, including cables.
Instructions for unpacking the LSR116 and verifying all included items are present.
Details on connecting the LSR116 to a host system via RS232 or USB interfaces.
Guidance on physically mounting the LSR116, including dimensions and mounting points.
Explains serial and USB connection types, including keyboard, HID, and CDC interfaces.
Steps for installing the serial (RS232) connection, including cable and power setup.
Steps for installing the USB connection, covering driverless keyboard, CDC, and HID modes.
Procedure to test the LSR116 after installation by presenting media for scanning.
Information on accessing and using the configuration tool for the LSR116.
Guidance on identifying and resolving problems encountered during installation or operation.
Instructions for cleaning the device and recommended storage conditions.
Provides a summary of the three operating modes: Dumb, Host, and Interactive.
Details on the one-way communication functionality of the LSR116 in Dumb mode.
Explains the two-way communication in Host mode, including accept/reject logic.
Describes the host-controlled two-way communication in Interactive mode.
Commands for setting device interface, baud rate, connection parameters, and operating mode.
Commands for adding prefixes and suffixes to barcode data, including clearing them.
Commands to control the imager's illumination, including adaptive modes and timing.
Commands to configure the behaviour of the 'Good Read' and 'Bad Read' indicator LEDs.
Covers firmware version checking, device resets, status LED control, and enabling/disabling barcode reading.
Commands for managing automatic and manual triggering of the imager.
Commands to display the 'Good Read' and 'Bad Read' counters.
Structure and example of HID input reports for data received from the LSR116.
Structure and example of HID output reports for sending commands to the LSR116.
Setting device status to activate 'read' lights using HID output reports.
