Page 19 of 34 Copyright © Access-IS 2016
Sets the delay between successful
reading of one barcode and the reading
of another barcode.
Each unit is equivalent to 1 millisecond.
5.2 Prefix and suffix solutions
These commands allow you to add a prefix and/or suffix to all barcodes.
Note: If you send more than one prefix or suffix to the device, they will stack in chronological order.
You must send a clear command if you want to use a single prefix or suffix.
Table 3. Prefix and suffix commands
Adds a prefix to all barcode
symbologies.
Any two-character hex ASCII code can
replace xx.
For example, to add STX (Start of Text)
as a prefix, use the command
PREBK29902.
You can add more than one prefix, as
required.
Adds a suffix to all barcode
symbologies.
Any two-character hex ASCII code can
replace xx.
You can add more than one suffix, as
required.
For example, to add CR (Carriage
Return) and ETX (End of Text) as a
suffix, use the command
SUFBK2990D03.
To Next Page
Loading...
