To Next Page
C
Christopher MccartyAug 18, 2025
What to do if the Access LORADO Automobile Accessories cover is too loose?
- KKevin McgeeAug 18, 2025
Turn both tension adjusters counter-clockwise to move the front bar forward.
What to do if the Access LORADO Automobile Accessories cover is too loose?
Turn both tension adjusters counter-clockwise to move the front bar forward.
What to do if the Access LORADO cover is too tight?
Turn both tension adjusters clockwise to move the front bar back.
How to fix a lopsided cover (too much on one side) on Access Automobile Accessories?
Check the front bar to ensure it is centered from side to side.
How to fix a loose Access LORADO Automobile Accessories cover?
To fix a loose Access Automobile Accessories cover, turn both tension adjusters counter-clockwise to move the front bar forward. See the arrows next to the adjuster in section #5C for reference.
Why doesn't the AUTOLATCHTM II engage on my Access Automobile Accessory?
Ensure the side rails are at the correct height and level. You may need to inspect the latches for any jammed or broken components.
What to do if the Access LORADO cover is too narrow?
Check if the rail is level. If the rail tilts up, loosen the clamp, lower it, engage the teeth, and then tighten it.
What to do if the Access Automobile Accessories cover is too wide?
Check if the rail is level. If the rail tilts down, loosen the clamp, raise it, engage the teeth, and then tighten it.
What to do if the tailgate hits the rear bar when closing my Access Automobile Accessories?
Raise the side rails at the rear of the box until the tailgate closes without pushing the rear bar up.
What to do if Access LORADO Automobile Accessories cover is too wide or too narrow?
If your Access Automobile Accessories cover is either too wide or too narrow, check the rails. If the cover is too wide, push all clamps to the top of the rail. If the cover is too narrow, pull all clamps down on the rail. Consult section #1D for visual guidance.
What to do if the top of the tailgate hits the rear bar when closing Access LORADO Automobile Accessories?
If the top of your tailgate hits the rear bar when you try to close it, raise the side rails at the rear of the box until the tailgate closes without pushing the rear bar up. Refer to section #5B for additional help.
Important instructions for the installer regarding reading instructions and customer service.
Advice for consumers on reading sections and saving the manual.
Contact details and operating hours for customer service assistance.
Steps to unpack components and clean the truck box before installation.
Instructions for attaching the side rails to the truck bed.
Detailed steps for securing and leveling the side rails using clamps.
Instructions for applying the weather seal around the front of the box.
Instructions for applying the seal to the rear of the truck bed.
Steps to attach the tension adjusters to the cover assembly.
How to mount the rolled-up cover onto the installed side rails.
Steps for unrolling, closing, and adjusting the cover tension.
How to check and adjust the cover's tightness for optimal performance.
Securing the cover using the hook and loop system for a tight seal.
Step-by-step instructions for rolling the cover to the closed position.
Step-by-step instructions for unrolling the cover to the open position.
Instructions for adjusting the storage straps to keep the cover secure.
An illustrated guide identifying all components of the tonneau cover system.
Common problems and their solutions for the tonneau cover.
Recommendations for maintaining the cover and extending its lifespan.
Guidelines for regular checks and upkeep of the tonneau cover.
Crucial safety precautions to observe while using and transporting with the cover.
General| Brand | Access |
|---|---|
| Model | LORADO |
| Category | Automobile Accessories |
| Language | English |