3030
Chapter 4: Using Your Meter’s Memory
Viewing Test Results
1. Press and release either or
(left or
right arrow button) to enter the meter’s
memory. If a code key is installed, the code
number appears briefly, followed by the most
recent test result stored in the memory. If no
code key is installed, code and
“---”
appear.
Press and release eith
er or again
to enter the memory and view the most
recent test result.
2. Press to view previous individual
results, or
3. Press
to view in order 7, 14, and
30-day averages respectively.
30-Day Average14-Day Average7-Day Average
Second Most
Recent Result
Third Most
Recent Result
And so on…
Third Most
Recent Result
Most Recent Result
Storing Test Results
Your meter automatically stores up to 480 test
results, and you can review them at any time.
If you’ve set the time and date on the meter
(see “Setting the Time and Date”), this information
is stored and displayed with your test results. If you
haven’t, test results are simply stored
in order, from the newest to the oldest.
The meter can also display 7, 14, and
30-day averages.
To Next Page
Loading...
Need help?
General
