Open the drum compartment and close it again.
Warning! The display showing the 90-day
“use-by” period will be lost (see Chapter 3).
Insert a test strip drum.
The meter cannot determine how long the test
strip drum has been outside the meter, or
whether it is still usable. If you are certain that the
3-month “use-by” period has not been exceeded,
you may continue to use the drum. Perform a
quality control check. The result of the quality
control check will be stored in memory along with
“CTRL”, and the drum symbol will remain
displayed until a new drum is inserted. If you do
not perform a quality control check, the flashing
drum symbol and the flashing “CTRL” will appear
with every new test until a new drum is inserted.
Until this point, all test results will be stored along
with the flashing drum symbol and “CTRL”.
Action
8180
11 Display messages
Display Cause
The bar code information
stored from the test strip
drum has been lost.
There is no test strip drum in
the meter.
You inserted a test strip drum
that has already been used.
Warning!
To Next Page
Loading...
Need help?
General
