27
Chapter 1: Your New Meter ACCU-CHEK Customer Service Center 1-800-858-8072
Notes:
• Do not operate without the nose cover attached. For more information, see
Chapter 5:
Maintenance and Troubleshooting.
• When applying blood, do not flood the test trip. Only a small blood drop is required.
• Do not bend the test strip.
• Never try to reuse a test strip that has been released from the meter.
• Do not open the test drum compartment when the motor is running.
• After a blood sugar result has been displayed for 60 seconds, the meter turns off automatically.
• If the display goes blank before the test strip is released, press to release
the strip and turn off the meter.
• Keep the test drum vial until you are finished with the test drum. You’ll need to refer
to the numbers on the label when you run a control test.
Proper Testing Conditions
• The temperature range must be between 50-104°F (10-40°C) for accurate results. At temperatures
outside this range, the meter turns off or results are displayed with a thermometer symbol.
Never artificially heat or cool the meter.
• Humidity must be below 85% so that moisture doesn’t condense on or inside the meter. If it does, let the
meter return to room temperature and thoroughly dry before turning it on.
Chapter 3: Testing Your Blood Sugar ACCU-CHEK Customer Care Service Center 1-800-858-8072
27
hold the black notch on
st strip to the blood drop.
m the site until the meter
splayed. You may apply
25 seconds after applying
gradually disappears and
yed in 8 seconds. Test
y stored in the meter’s
ght, press to
nd turn the meter off.
ake off the lancet device
et end away from yourself.
discharge the lancet into a
er.
about your test results,
ur Test Results.
are Service Center 1-800-858-8072
Gradient box behind
“Notes” prints 5m,
20y, 1k to white.
“
Proper Testing
Conditions
” prints
27m, 100y, 6k.
361_26758_Manual_AC_Compact.qxp 6/27/05 11:35 AM Page 27
To Next Page
Loading...
Need help?
General
