3. Measurements Procedure
When the power is turned on, the measurement starts.
1) Basic Procedure
There are two ways to measure impedance; Plate electrode or Ankle electrode.
Either one can be selected at the SYSTEM SETTING.
① Measure weight
- When the power is on, the initial screen appears as
shown in the picture.
- The following message appears.
"To start, please measure your weight"
- When the user steps on the scale, the
measurement starts with a chime bell. If the user
moves on the scale, voice guidance warns as
follows.
"Don't move or speak please"
- After the weight measurement, the screen changes
as shown in the picture.
Input ID②
- Input an ID.
- ID can have up to 20 characters
- Press “DONE” to save after input.
To Next Page
Loading...