Press the key.
The unit will perform a zeroing operation and the weight to be calibrated will
be displayed (default total capacity - e.g. 60.00)
If you want to change the calibration value, press the key and 0000.00
will appear.
Press until the digit to be modified flashes, then press to modify
it to the desired value (e.g. 10k = 0010.00)
Place the calibration weight on the scale.
Once the weight has been deposited, press the key and the calibration
will be performed and the actual weight will appear.
Calibration completed.
4. A/D Counts Display
Press【ON/*】three times, display〖-A-d-〗, press【→T←】, display〖123456〗, A/D (Digital/Analog)
counts 123456, press the【ON/*】to return to weighing mode.
5. Select Display Mode
In normal weighing status, press【ON/*】for 2 seconds, unit of weighing is lb, press【ON/*】for
2 seconds, unit of weighing is kg.
6. Zero
When the weight is stable, press【→0←】, display〖 0.00〗, zero status LED is turned on. Zero
range is ± 2%FS.
To Next Page
Loading...
Need help?
General
