Installation & Operation Manual - Model AVC6000
Contents of this Manual are Subject to Change Without Notification Page 16
SECTION 6 – ACCUVALVE INSIGHT CONFIGURATION SOFTWARE
AccuValve Insight is a software configuration tool that provides a means to communicate
directly with the AVC AccuValve. All that’s required is a Windows 10 computer or tablet with a
USB Port, USB cable and the AccuValve Insight Software. For wireless communication, the AVC
can be ordered from the factory with an optional Bluetooth module.
6.1 Minimum Requirements for PC
• Windows 10 computer or tablet with a USB 2.0 port
• Bluetooth v 4.2 (or later) (Required Only for AVC6xxx-W Optional Wireless)
6.2 Installing the AccuValve Insight Software
Before starting the install process, close any programs running on the computer.
• Download the AccuValve Insight Software from http://www.accutrolllc.com.
• Run setup and follow the on-screen instructions.
6.3 AccuValve Insight Software Product Registration
After the software has been installed on your computer, you will need to register the product
and obtain a valid software key from the factory by performing the following steps.
Note: This process will require an automatic email to be generated from your computer,
therefore you will need to have internet access to generate the key request.
a. Double click on the desktop shortcut created during installation.
b. Complete the Product Registration Form.
c. Select “Request Product Key” to generate a “key request” email to the factory.
d. The factory will issue a Product Key to the email provided on the Registration Form.
e. Copy and paste the Product Key into the field provided at the bottom of the form then
select “Register Product Key”.
f. You will now be able to use the AccuValve Insight Software on this computer. If you
have any problems, contact Accutrol LLC at 203-445-9991.
To Next Page
Loading...
Need help?
General
