Installation & Operation Manual - Model AVC6000
Contents of this Manual are Subject to Change Without Notification Page 7
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at the user’s own
expense. This Class A digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Units provided with the optional Bluetooth low energy module contain
FCC ID: XPYNINAB1
IC: 8595A-NINAB1
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions;
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
KCC South Korea compliance certification number MSIP-CRM-ULX-NINA-B111
Australia and New Zealand regulatory compliance. The NINA-B1 modules are compliant with
AS/NZS 4268:2012?AMDT 1:2013 standard – Radio equipment and systems – Short range
devices – Limits and methods of standard measurement made by the Australian
Communications and Media Authority (ACMA)
MATERIALS OF CONSTRUCTION
Model Code Material Designator
Polyurethane,
Ether-based
Polyurethane,
Ether-based
Polyurethane,
Ether-based
To Next Page
Loading...
Need help?
General
