Acecad DigiMemo L2 - Problems When Connecting the Digital Pad to Your Computer

Problems When Connecting the Digital Pad to your Computer
Problem: When connecting the digital pad to your computer through a USB
port, your Windows can not recognize the built-in 32 MB storage
device and an optional memory card in the pad as removable storage
devices.
Solution:
wer to the
USB hub while connecting the digital pad via an USB hub.
if your Windows can not recognize them, please
Problem:
Please verify the followings:
z The USB port is available.
z Make sure that a power adapter provides enough po
z We recommend you connect the digital pad directly to an USB
port on the computer.
Occasionally,
z
restart your Windows.
Before disconnecting the digital pad from your computer, what should
be noticed?
Solution: The following stated notice is applied for all removable storage
devices. Close any associated windows for the built-in 32 MB storage
device or an optional CF memory card before attempting to
disconnect the digital pad from your computer.
38